Zk-pp2k Manual

The fundamental principle behind the module is Pulse Width Modulation (PWM), a technique used to control the average voltage or power delivered to a load by toggling the signal on and off at a high speed. The key parameters of this "toggling" are the (how fast it toggles) and the duty cycle (the percentage of time the signal is ON versus OFF).

Let the magazine warm to room temperature. Relubricate the internal nozzle O-ring. Hop-up is completely turned off or bucking is torn.

The module has anti-reverse protection, but ensure input voltage does not exceed 30V. Zk-pp2k Manual

Check your load current. The ZK-PP2K outputs less than 30mA. You must use an external MOSFET or relay module to handle the high current demands of a motor.

Short-press SET to cycle through parameters: P+: Positive pulse width time (seconds). P-: Negative pulse width time (seconds). N: Number of pulses (1-9999, or ---- for infinite). D: Delay time before starting. The fundamental principle behind the module is Pulse

Displays real-time parameters with clean, backlit readability.

DC 3.3V to 30V (with anti-reverse protection) Frequency Range: 1Hz to 150KHz Relubricate the internal nozzle O-ring

This mode allows precise control over pulse width, delay, and the specific number of cycles. ZK-PP2K Signal Generator